Thursday, July 18, 2013

Removing an Olympia Badge

No, the title of this post is not a metaphor. Although I am gifted in mystical arts of the metaphoric, what I am taking about is far more literal. I wanted to give you a few tips on removing this troublesome little piece of decorative metal.



Olympia badges on the 1950s varieties (SM-2, SM-3, SG-1, etc.) are high-quality aluminum castings that are adhered to the body of the typewriter by four sprue. Each of these four legs are placed in a corresponding hole and the ends deformed. The deformation holds the badge fast and makes for a very strong connection. Come to think of it I have never seen a badge-less Olympia. Quality German engineering.



Removing the badge is not for the faint of heart. You must drill out the deformed end of the sprue just enough to ease the badge from the mounting holes. To do this you need an electric drill and a steady hand.

I used an electric hand drill fitted with a bit only slightly larger than the sprue. Starting slowly, I drilled out the end taking care to only drill enough to get rid of the riveted end. In place of the rivet-like end you will se shiny, bare metal in a slight concavity. This concavity will play an important part in reassembly. 



After the drilling, I took a very thin bladed screw drive and carefully eased the badge out of the mounting holes. The aluminum badge can be bent easily, so make sure that you are prying up near a sprue.



There you go. Your Olympia cover is badge-less and ready for refinishing.

When you want to reinstall the badge, just fit it back together and put four small beads of JB Weld in the concavities made while drilling. After the JBWeld is cured, you can put the felt back and it should be as good as new. This process can also be done for the riveted badge from the back of the machine.